Technical Requirements for Plastic Injection Molds

Aug 07, 2026

The design and manufacture of plastic injection molds must be determined based on the product's structure, material properties, dimensional accuracy, and production volume; the overall mold structure must possess sufficient strength and rigidity to withstand the pressures generated during the injection process. Key molding components, such as cores and cavities, must meet the dimensional requirements specified in the product drawings, and mating surfaces at the parting line must fit precisely, without significant misalignment or flash. The machining and assembly precision of all mold components must satisfy molding requirements, ensuring stable operation during continuous production.

 

The gating system should be rationally designed based on the plastic material and product structure to ensure the molten plastic enters the cavity uniformly and smoothly, thereby minimizing molding defects such as short shots, weld lines, air bubbles, and sink marks. Gate locations and dimensions should facilitate molding and subsequent trimming, while the venting system must be positioned to capture trapped air and ensure its timely evacuation from the cavity. For products with complex structures or lateral undercuts, mechanisms such as slides and lifters should be properly incorporated to ensure smooth mold opening and prevent product deformation or damage during ejection.

 

The mold cooling system should be configured according to the product shape and molding cycle; the placement, spacing, and diameter of cooling channels must be optimized to ensure uniform cooling across all cavity areas. The ejection system should utilize appropriate ejector pins, blocks, or sleeves based on the product's structural load, ensuring balanced force distribution during ejection. Guide pillars, guide bushings, slides, and other moving parts must operate smoothly, with necessary lubrication applied to prevent issues like jamming or uneven wear that could disrupt normal mold operation.

 

Upon assembly, the mold must undergo trial runs and inspections, focusing on product dimensions, appearance, demolding performance, the molding cycle, and the proper functioning of all mold mechanisms. Any issues identified during trials-such as flash, sink marks, deformation, stress marks (whitening), or surface scoring-must be promptly analyzed and rectified through mold adjustments. Once the mold meets production standards, molding surfaces should undergo necessary polishing or texturing, non-molding surfaces should be treated for rust prevention, and the mold must be properly marked, maintained, and stored to ensure a long service life and consistent mass production quality.